Belt Pack Transmitter - Gemini VHF-01-Serie Bedienungsanleitung

ENGLISH

BELT PACK TRANSMITTER

PARTS DESCRIPTION
1. Power ON/OFF/MUTE Switch
2. Power/low batter indicator
3. MIC in jack
4. Battery Compartment/Cover
OPERATION
1. Open battery cover. Install the provided 2pcs 1.5V AA batteries
and then close the cover. Pay attention to the correct polarity.
2. Insert headset MIC or clip-on MIC plug into MIC IN jack. And
turn plug clockwise to lock the headset MIC.
3. Slide power switch to ON position, power indicator should flash
once briefly indicating that the transmitter has sufficient power.
If the power LED indicator stays on, it indicates that the battery has
insufficient power and should be changed. If the power LED
indicator does not light at all and the transmitter does not work,
it indicates the battery is dead and you should change the battery.
4. Now receiver RF indicator should light. Please confirm frequency
of transmitter is same as receiver before operation.
5. Slide power switch to MUTE position to mute the sound.
6. If the transmitter is not going to be used for any length of time,
push the power switch to OFF position and remove the battery.
8
2 3
1
VHF-01, 02 manual
•
4
geminisound.com