National Instruments NI-DAQmx Installationsanleitung Seite 5

Connecting or disconnecting the disk drive power connector can affect
the analog performance of your device. To compensate for this,
NI recommends that you self-calibrate the PCI Express DAQ device in
MAX after connecting or disconnecting the disk drive power connector;
refer to the DAQ Getting Started Guide at Start»All Programs»
National Instruments»NI-DAQ»DAQ Getting Started Guide.
7. Replace the computer cover, if applicable.
8. Plug in and power on your computer.
PXI and PXI Express Devices
Complete the following steps to install a PXI and PXI Express device:
1. Power off and unplug the PXI/PXI Express chassis. Refer to your chassis
manual to install or configure the chassis.
Caution
Compatibility with your PXI/PXI Express chassis or device before
removing covers or connecting or disconnecting signal wires.
1 PXI/PXI Express Chassis
2 PXI/PXI Express System Controller
3 PXI/PXI Express Module
4 Injector/Ejector Handle
Figure 4. Installing a PXI
2. Identify a supported PXI/PXI Express slot in the chassis. Some devices
have PXI/PXI Express slot requirements; for information, refer to the
device documentation.
© National Instruments Corporation
Refer to the Read Me First: Safety and Electromagnetic
2
3
4
1
P X
I - 1
0 0 0
B
6
5
5 Front-Panel Mounting Screws
6 Module Guides
7 Power Switch
/
PXI Express Device in the Chassis
5 NI-DAQmx and DAQ Device Installation Guide
7 7