Troubleshooting Guide; Wiring Diagram - Guzzanti GZ-19 Gebrauchsanleitung

PROBLEMS WITH YOUR APPLIANCE?
You can solve many common unit problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Unit does not operate.
Turns on and off frequently.
Vibrations.
The unit seems to make too much noise.
The door will not close properly.
PLUG
2 0V~ 2

TROUBLESHOOTING GUIDE

WIRING DIAGRAM

CONTROL PCB
FAN CONTROL DC12V
DISPLAY
LED
POSSIBLE CAUSE
Not plugged in. The circuit breaker tripped or a
blown fuse.
The room temperature is hotter than normal.
A large amount of food has been added to the
unit. The door is opened too often. The door is
not closed completely. The temperature control
is not set correctly. The door gasket does not
seal properly. The unit does not have the correct
clearances.
Check to assure that the unit is level.
The rattling noise may come from the flow of
the refrigerant, which is normal. As each cycle
ends, you may hear gurgling sounds caused by
the flow of refrigerant in your unit. Contraction
and expansion of the inside walls may cause
popping and crackling noises. The unit is not
level.
The unit is not level. The door was reversed
and not properly installed. The gasket is dirty or
bent. The shelves, bins, or baskets are out of
position.
DC12V