Connecting The Power Cord - Teleco TFV20D Bedienungsanleitung

To turn off the television : Press and hold down the
centre of the Down button for a few seconds until the
television enters Standby mode.
Putting batteries in the remote control
Lift the cover at the back of the remote control.
Insert two AAAsize batteries. Make sure that the +
and – ends of the batteries match the in the battery
compartment (respect the right polarity). Put the cover
back in place. Don't mix different type of batteries or
new and used batteries.

Connecting the power cord

IMPORTANT: The TV set is designed to operate on
110-240V AC, 50/60 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna Connection
Connect the aerial or cable TV plug to the AERIAL
INPUT (ANT) socket or satellite plug to SATELLITE
INPUT (LNB) socket located on the back of the TV.
REAR
OF
THE TV
Notification
Manufactured under licence from Dolby Laboratories
MANUFACTURED UNDER LICENCE
"Dolby" and the double D symbol are trademarks of
Dolby Laboratories.
HDMI, the HDMI logo and the high definition
multimedia interface are marks or registered
trademarks of HDMI Licensing LLC.
satellite
aerial
or
cable
English - 49 -
Information applicable to users in relation to
disposal of old devices and batteries
[European Union only]
This symbol indicates that the equipment should not
be disposed of as household waste. If you have to
discard the TV set or the batteries, consider using
collection systems or infrastructure for appropriate
recycling.
Note: The Pb sign inscribed on the batteries indicates
that the battery contains lead.
Products
Technical details
TV Frequency (tuner)
Number of memorable
channels
Audio standard
On screen display
RF Input Socket
Operating voltage:
AUDIO OUTPUT
POWER (WRMS.) (10%
THD)
Power consumption
st-by power
consumption
Weight Stand
TV Dimensions DxLxH
(with foot)
TV Dimensions DxLxH
(without foot)
Operating temperature
and humidity
Battery
VHF (BAND I/III) - UHF
(BAND U) - HYPERBAND
10000
German +Nicam Stereo
On Screen Display
75 Ohms (unbalanced)
110-240V AC, 50/60 Hz.
2 x 2,5 WRMS
45W (max)
1 W (max)
3,30 kg
134 x 473 x 328 mm
55 x 473 x 294 mm
0ºC up to 40ºC, 85%
humidity max