Fitting The Handle - Garden 89041 Gebrauchsanweisung

Fitting the handle

GB
Subnumbers refer to the drawing on the
rear of the user instructions.
Fit the top section of the handle (76) on
each side of the bottom part of the handle
(69) using a bolt (75), a crank (74), a washer
(11), two outer fl anges (73), two bracket
parts (72) and a nut (31).
Fitting the brush and handle to the
angle adjustment
Subnumbers refer to the drawing on the
rear of the user instructions.
Place a conical brush (6), fi ve spacers (5), six
straight brushes (4) and a cap (3) on each
axle (7), and secure them using a washer (2)
and bolt (1).
Fit the handle to the brush's angle
adjustment using a bolt and nut.
36
Adjusting the height of the sup-
port wheels
As the brush becomes worn, you must
adjust the height of the support wheels
so that the brush is always touching the
ground when it moves around.
Pull the locking split pin out of the support
wheel's vertical axle, remove the washer
and take off the support wheel.