Technical Specifications; Functioning Of The Keys And Messages; Installation - Roger Technology H85/TDR Serie Anleitungen Und Hinweise Für Den Installateur

3

Technical specifications

NUMBER OF STORABLE USER CODES
MAXIMUM NUMBER OF DIGITS PER USER CODE
MINIMUM NUMBER OF DIGITS PER USER CODE
BIT NUMBER OF THE IDENTIFICATION CODE OF THE
KEYBOARD
NUMBER OF CODE COMBINATIONS
NUMBER OF BITS TRANSMITTED
TRANSMISSION FREQUENCY
MODULATION TYPE
MAXIMUM DISTANCE OF OPERATION IN FREE FIELD
AVERAGE CONSUMPTION WITH ACTIVATED KEYBOARD
BATTERIES
BATTERY LIFE
OPERATING TEMPERATURE
PROTECTION RATING
PRODUCT DIMENSIONS
4

Functioning of the keys and messages

The keys 0 to 9 along with the keys * and # allow
the activation of the change of password sequences,
the save/delete code, the full deletion of codes and
more. Four keys have a dual function since they are
also used to activate the radio broadcast:
• Key 1 / A: activation of the radio channel CHA
• Key 4 / B: activation of the radio channel CHB
• Key 7 / C: activation of the radio channel CHC
• Key * / D: activation of the radio channel CHD
The A,B,C,D channel keys do not have a
predetermined function and can be stored on any
function of the radio receiver.
The keyboard has a green LED and a red one (see
Figure 1, Detail A: LV and LR, respectively), and
a buzzer: these are used to give messages while
typing and during the various stages of operation.
During the radio broadcast:
- in fixed code mode the red LED flashes
- in "rolling code" mode the green LED flashes.
5

Installation

Before attaching the keyboard into the appropriate
slot:
• Connect the batteries to the keyboard connector
(see Figure 6 details D, F).
• Change the security password (see section 5.1
CHANGE PASSWORD); write down the new
450
6
3
16 (fixed code) - 32 ("rolling code")
65536 (fixed code) - 4.294.967.296 ("rolling code")
28 (fixed code) - 144 ("rolling code")
433.92 MHz
AM / ASK
100m
12mA
2 x CR2032
minimum 2 years with 10 activations/day
-10°C ... +55°C
IP54
H85/TDR/I size in mm. 75x77x60 Weight: 119g
H85/TDR/E size in mm. 75x77x41 Weight: 114g
H85/TDR/C size in mm. 75x98x58 Weight: 256g
password in an adequate and secure place. Upon
performing the password change you also enable
the transmission mode (fixed or "rolling" code).
CAUTION! A change of password is required
in order to maintain the level of security of the
installation, otherwise a code could be stored in
a fraudulent manner thus allowing an attacker to
activate radio commands using this fraudulent
code.
• Deleting saved user codes (see section 5.2
COMPLETE DELETION OF USER CODES).
• Storing at least one user code in the keyboard
memory (see paragraph 5.3 STORING A USER
CODE).
• Determine the maximum number of radio
functions you want to activate on the receiver
or receivers envisaged in the installation: this
determines the number of channel keys to be
enabled on the keyboard.
• Store the aforementioned keyboard channel keys
on the receiver (see paragraph 5.4 STORAGE ON
THE RECEIVER)
• Verify, when placing the keyboard, that the
intended installation point allows for the remote
operation of the receiver; if the placement
distance does not guarantee good transmission,
change the installation point or evaluate the
positioning of the receiver's antenna (or, if absent,
its installation)
After completing these operations you may now
1
9