Troubleshooting - Bahco BE210 Bedienungsanleitung

English

Troubleshooting

Transferring Photos and Videos to a computer
In order to use this function, the computer must be running MS WindowsTM 2000 or
younger version.
Turn the Video Scope on. Connect the USB cable to the scope unit and the computer.
Look for the drive with the SD card files,
this should look similar to the following figure:
DCIM
The files can then be transferred and viewed on the computer.
If the computer is running the correct operating system
(MS Windows 2000 or a younger version of Windows)
no special software is required to display JPG
and ASF files by using Windows MediaPlayer.
5. Troubleshooting
Problem: No image on the display after turning the power on
Solution: The battery is exhausted. Connect the scope unit to the power adapter supplied
and recharge the batteries.
The Video scope can be used when connected to ac power.
Problem: Only words appear on the LCD monitor, and no image is shown, after turning
the power on.
Solution: Check that the insertion tube is correctly connected to the display unit.
Problem: It is not possible to take pictures or record videos:
Solution: The SD card is either not inserted, is wrongly inserted, full or faulty. Refer to
Preparation for use (section2) for guidance on how to insert the SD card.
Check the SD card capacity or if it is faulty (by using it in other devices).
Problem: All functions freeze or fail.
Solution: Insert an insulated needle into the hole on the back of the main unit.
The system will restart automatically.
100DSCIM
32
IMG00001.JPG
IMG00009.AVI