Cleaning & Maintenance - KitchPRO 17120 Bedienungsanleitung

EN
Press the "On/Off" button to turn on the kettle,
the control panel display will show "ON"
Press the "Menu" button to select function
(boiling, sterilization, 45°C or keep warm), the
corresponding indicator light will then light up
HOW TO SELECT FUNCTION
Press the "Menu" button until the indicator
light corresponding to the desired mode lights
up. It will flash for a couple of seconds (during
this time you can press "Menu" again to switch
mode) and when the light is steady the heating
will begin accordingly to the selected mode.
The display shows the current water tempera-
ture.
Boiling
When the water is boiling, the kettle will con-
tinue to heat for 15 seconds, then it will beep
and the display will show "End". The kettle will
now automatically enter the Keep Warm mode.
Sterilization
When the water is boiling, the kettle will con-
tinue to heat for 3 minutes. After that, the kettle
will beep and the display will show "End" to
indicate this. The kettle will now automatically
enter the Keep Warm mode.
45°C
The kettle will heat the water until the water
temperature reaches 45°C. Then, the display
will show "End" and the kettle will beep to indi-
cate this before it goes into Standby mode.
Keep Warm
The kettle will automatically heat up the water
to 50°C (this is indicated by a beep) and will
then maintain this temperature for as long as
24 hours. After this time, the kettle returns to
Standby mode.
CLEANING & MAINTENANCE
• Before cleaning and storage, make sure the
kettle is unplugged and has cooled down
completely.
• Do NOT immerse the kettle into water
• Do NOT use abrasive cleaners for the kettle
• Do NOT clean the kettle in a dishwasher, to
avoid the risk of deformation or explosion
• The included silicone mugs are top-rack
dishwasher safe
• Before first use, and to keep the kettle clean
when it's not been used in a while, please
follow these steps to clean it:
• Add 2 dl vinegar into the pot and let sit for
about 1 hour (do not turn the kettle on)
• Pour the vinegar out, wipe off leftover re-
sidual with a damp cloth
• Fill the pot with 0.6 litres of water
• Press "Menu" function and select "Boiling"
mode, the corresponding indicator light will
light up. Do not press any key for about 3
seconds and the kettle will start automati-
cally
• When the water is boiling, pour it out and
add a new 0.6 litres of water to the pot
• Repeat the cleaning process of steps 4 and 5
approximately 5 times
• If necessary, repeat the boiling process sev-
eral times, until the water neither smell or
taste vinegar
• Use a soft, damp cloth to wipe the outside
of the kettle