Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Putting up your dance pole without screwing it into the ceiling
You may need: Stepladder/Stud Finder/Pencil/Tape Measure/Spanner/
STEP 1
•
Make sure you have a concrete or plasterboard ceiling. Ask the opinion of a qualified builder or han-
dyman if you are not sure.
•
If you have a concrete ceiling, you can position your dance pole wherever you want.
•
If you have a plasterboard ceiling, the dance pole must be positioned under a ceiling joist. A ceiling
joist is a wooden beam that runs underneath the plasterboard. We recommend you use a stud finder
to locate the joist(these are available from most DIY stores). Follow the instructions that accompany
the stud finder until you are sure you've found a ceiling joist, then mark it with a pencil. If unsure,
consult a qualified builder/handyman.
STEP 2: Measure the height form floor to ceiling.
STEP 3
•
Connect the ceiling plate to the top rod, making sure the pushpins click into the position.
•
Connect the base plate into the bottom rod by slotting them together, making sure that the screwth-
read is at its lowest level.
•
Squeeze the fat end of the middle rod down into the skinny end of the bottom rod.
•
Attach the wide end of the top rod onto the small end of the middle rod.
•
Unscrew and extend the top rod so that the height indicator displays your ceiling height.
•
Ask a friend to hold the dance pole in an upright position between the floor and the ceiling. Remember
that you must position the ceiling plate under a ceiling joist if you have a plasterboard ceiling. Mark
a position spot with your pencil.
•
At the bottom of the screwthread locate the two flat points between the two nuts.
•
Engage the enclosed spanner with the flat points and turn it gently clockwise so that the screwthread
lengthens. Continue turning until the base of the dance pole is on the floor.
•
While your friend holding the dance pole, step back and ensure it's perfectly upright. Adjust the po-
sition of the base of the pole until it is achieved.
STEP 4: Engage the enclosed spanner with the flat points on the screwthread again and turn it clockwise
so that the screwthread lengthens further. Continue turning until the measurement on the screwthread
corresponds to the height of your ceiling.
STEP 5: Tighten the two nuts at the top and the bottom of the screwthread.
STEP 6: Apply force to the dance pole from the side to check it doesn't slip from its position. If there is
any slipping movement, loosen the nuts and gently lengthen the screwthread a little further until there
is none. Make sure the dance pole is straight before the nuts are tightened back into place.
STEP 7: Gently grab the uppermost section of the dance pole, and apply successively greater weights
until your entire body weight hangs from this section of the dance pole. If there is any movement, loosen
the bolts and return to lengthening the screwthread, making sure that the dance pole is straight before
re-tightening.
Assembly
Method 1
6
Werbung
