Using The Device; Cleaning And Maintenance - Marta MT-2499 Bedienungsanleitung

 This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for their safety.
 The heater should be placed on a flat, steady surface with min 100 cm air gap from walls, window curtains or furniture.
 Do not use the heater near the basins, shower, sinks, swimming pools or other places where it may get wet.
 Do not place any inflammable substances and objects subjected to deformation near the heater.
 Be careful when using the heater near children.
 Make sure that there is enough space for proper operation of the heater: at least 1 m in front and 50 cm behind the heater.
 Do not let animals or children touch or play with the fan heater. Pay attention! The air outlet gets hot during operation (more than 80°С).
 Keep the fan heater clean. Do not allow any objects to enter any ventilation or exhaust opening as this may cause electric shock, or fire or damage to the heater. Always use the heater in
the upright position.
 Do not use the appliance in rooms less than 4m² area.
CAUTION: Do not cover the appliance when it is in use. If covered, there is risk of overheating.

USING THE DEVICE

 Insert the plug to the power supply.
 Set the mode control according to your wish:
For model МТ-2521:

Ventilation mode: turn the knob to setting «

Heating at reduced power: turn the knob to setting «I»（1000W）

Heating at full power: turn the knob to setting «II» (2000W)
 Switching off: turn the knob to setting «O»
SAFETY SYSTEM
To avoid damage of internal components, the fan heater has a safety device which will automatically switch off the appliance in case of accidental overheating. If this happens the heating
element will turn off, but the fan will continue to run to help cool the heater. If overheating occurs:
 Turn the mode control switch to "O" position and remove the plug from the socket.
 Let the fan heater cool down for a few minutes before you start it again.
 Remove the cause of overheating.
 Plug in the appliance and switch it on. If the appliance can‟t operate normally, remove the plug from the socket immediately and have the fan checked in the service center.

CLEANING AND MAINTENANCE

 Switch off the appliance and unplug it from the power supply and allow cooling down.
 Switch off the appliance and unplug it from the power supply and allow cooling down. Wipe the outside of the appliance with a soft damp cloth. Clean the air inlet/outlet grilles regularly.
SPECIFICATION
Model Power supply
MT-2499 220-240 V , 50 Hz
MT-2521 220-240 V , 50 Hz
»
Power Net weight / Gross weight
1500 W 1,06 kg / 1,23 kg
2000 W 0,8 kg / 0,94 kg
For model МТ-2499:

Ventilation mode: turn the knob to setting «

Heating at reduced power: turn the knob to setting «I»（750W）

Heating at full power: turn the knob to setting «II» (1500W)
 Switching off: turn the knob to setting «O»
Package size (L х W х H)
190 mm х 138 mm х 232 mm
200 mm х 132 mm х 232 mm
6
»
Producer:
NINGBO BASLLY ELECTRICAL APPLIANCE CO.,LTD
NO.2 Weiyi Rd, Fanshi Town, Cixi, Ningbo, P.R.China
Made in China