Operation; Accessories; Maintenance; Service - Magnaflux Y-2 AC Yoke Betriebsanleitung

OPERATION

1.
Attach power cord, making sure connection is secure. Connect the power supply to line power.
2.
Position yoke legs at right angles to the direction of suspected discontinuities. Adjust legs
as needed for best contact with surface.
3.
Depress trigger to energize yoke. Apply magnetic particles to area between legs. While
energized, blow off excess powder to reveal indications. To switch from UV mode to
visible light mode, press and hold the power button for 3 seconds.
4.
Evaluate indications for size, shape, and relevant locations.
5.
Reposition yoke legs at 90-degrees to previous position and repeat steps 2-3 to reveal
indications in all directions.
6.
Demagnetize by slowly withdrawing yoke from surface, up to 18 in / 45 cm distance, while
yoke is energized.
7.
OPTIONAL YOKE LIGHT: To install, slide over the rear leg with LEDs facing in. Push up
onto the housing until tabs are secured. Yoke light will automatically operate when yoke is
energized. To remove, pull sides out and down to disengage tabs, then slide off. No tools
are necessary for installation or removal.

ACCESSORIES

Part No. Description
628840 Yoke Light, Y-2
624115 Calibrated Test Weight, 10 lb

MAINTENANCE

CLEANING
•
Use mild soap and a damp cloth to clean the yoke housing
•
Do not immerse any part of yoke in liquid
•
Legs may be detached at the joints for cleaning
•
Use a rust-preventative spray (LPS-3 or equivalent) on legs for lubrication
DISPOSAL
The Y-2 contains no hazardous materials and complies with EU RoHS regulations. Please
contact your local waste disposal authority for instructions on disposal of electrical waste.

SERVICE

CAUTION
To assure product safety and reliability, repairs should be performed by
Magnaflux Authorized Service Center using original parts.
WARNING
If the yoke housing is opened for any reason, warranty is voided on the unit.
Y-2 Yoke Operating Manual
3