Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fitting Instructions
2. Installation
a. All components and accessories should
be organised first.
b. Check the light before the installation to
ensure that it works correctly (the red line
is positive, the black line is negative).
c. Place the spring washer on the fixing
screw. Insert the fixing screw through the
holder of the worklight (see Figure 1).
d. Guide the screws through the mounting
holes and mount the spring washer. Then
tighten the hexagon nuts (see Figure 2).
5
e. Connect the plus line and the minus line.
f. Ensure that the light has been mounted se-
curely and check the function of the work-
light.
Insert the
hexagon screw
4. Notes
Spring washer
a. If cracks are visible on the light in the cas-
Hexagon nut
ing or in the glass and plastic parts, the
light no longer fulfils the requirements
and should not be used.
b. The power supply should be interrupted
Figure 1
during installation to help prevent injuries.
80690316
Tighten the
hexagon nut
Mounting plate
Tighten the
hexagon nut
Figure 2
Technical data:
EN
Werbung
