Technical Data; Installation - Motostar LIVIMN-B Installationsanleitung

D
M/S
E
F
G
SLAVE
MASTER
M/S
2
1
Master/Slave selector switch (M/S) D
If two or more receivers have been set up to respond to the
same call, the preview image of the caller is shown only on
the master receiver(s).

Technical data

Type
Power supply from BUS (VDC)
Consumption (mA max)
Consumption in stand-by mode (mA)
Local power supply (VDC)
Consumption (mA max)
Consumption of single LED (mA) (pan-
ic alarm, disabling ringtone)
Storage temperature (°C)
Operating temperature (°C)
IP Rating
Video standard
LCD TFT colour display (inches)

Installation

Install the device at a suitable height for the user.
E Press button 1; unhook the bracket from the device by
•
sliding it along 2.
Fasten the bracket to the recessed box:
•
round Ø 60mm F or rectangular 503 GH. Use the screws
provided, follow the direction marked "TOP" and avoid over-
tightening the screws.
H
LIVIMN-B
LIVIMN-N
15÷20
410
<1
16-18
370
1
-25 to +70
0 to +35
20
PAL/NTSC
7