Texas A/S HS619TG Bedienungsanleitung Seite 15

Operation safety zone
Do not leave the operation safety zone marked in
figure 14, while working with the machine. If it is
necessary to leave the operation zone, for example to
readjust the rotary brush or to attach an accessory,
first stop the engine.
Height adjustment of brush
When the brushes become worn it might be necessary
to adjust the proximity of brushes to the working
surface. To adjust the height of the brushes follow
figure 8:
1. Remove the lock pin
2. Lift the front of the machine to free the brush
and pull the supporting wheels out.
3. Remove or add the spacer ring
(1 ring = approx. 5 mm)
4. Install support wheels, remove / add spacer
ring, fasten with locking pin.
(Hint: Complete one wheel at a time)
Angle adjustment of brush
The brush can be pivoted 20 degrees to either side.
This is done by pushing the swing handle down,
turning the brush and releases the handle so the
detent clicks into place.
The swing handle is shown on Figure 7, H.
Technical specifications
Model
Total width (mm)
Working width (mm)
Weight w/o fuel (kg)
Brush diameter (mm)
Swinging brush
(positions)
Gears (forward/reverse)
Tire size
Tire pressure (psi)
Model
Total width (mm)
Working width (mm)
Weight w/o fuel (kg)
Brush diameter (mm)
Swinging brush
(positions)
Gears (forward/reverse)
Tire size
Tire pressure (psi)
HS640TG
HS619TG HS645TG
HS650TG HS690TG HS650TGE
610 610 610
600 600 600
71 71 72,5
350 350 350
3 3
3+1 3+1 3+1
13 x 4.10 13 x 4.10 13 x 4.10
24 24
HS710TG HS710B HS710TG
710 710 710
700 700 700
75 75
350 350 350
3 3
3+1 3+1 3+1
13 x 4.10 13 x 4.10 13 x 4.10
24 24
Troubleshooting
Problem Solution
The engine won't start:
The engine runs unevenly:
If the brush will not run:
If the machine will not run:
If the machine does not sweep effectively:
3
24
75
3
24
15
1. Check sparkplug.
2. Check that the spark plug cap is fitted
correctly.
3. Check if the motor is equipped with an
ignition switch.
(It must be activated)
4. Check if the motor is equipped with a
fuel valve.
(It must be activated)
1. Check that the choke has been
released.
2. Check fuel for impurities.
1. Check that the clutch cable is adjusted
correctly (figure 6).
2. Check that the belt is tight.
1. Check that the clutch cable is adjusted
correctly (figure 6).
2. Check the belt.
1. Check the distance between the brush
and working surface.