Velleman HAA263D Bedienungsanleitung Seite 3

5. Installation
• This keypad should be installed and serviced by a qualified person only.
• Choose an easily accessible location where the keypad is protected from harsh environmental
conditions such as rain and bright sunlight, and away from heat producing devices.
• Have a qualified person installing the electrical leads (4) that are necessary for the connection of
the keypad to the master control unit.
• Remove the keypad from the mounting frame by removing the screw at the bottom and pulling
gently forward.
• Mount the mounting frame over the leads coming from the master control unit. Do not damage
the leads when doing this.
• Remove the back cover of the keypad by removing the screws at the four corners.
• Make sure there is no power on the leads. Connect the leads to the connector block in the keypad
as indicated on the PCB.
• It is also possible to install a tamper switch (not included).
• Re-mount the back cover with the 4 screws.
• Place the keypad back in the mounting frame. Make sure the cabling is not damaged in the
process. Remount the screw at the bottom.
• Apply power to the leads (via the master control unit).
• There are no user-serviceable parts. Contact your dealer for spare parts if necessary.
6. Keypad description
A. General status LEDs
EXIT/ARMED ON
OFF
Flash
AC POWER ON
Flash
Flash Alternatively
with Battery LED
BATTERY ON
OFF
Flash
Flash Alternatively
with AC power
LED
PROGRAM ON
OFF
PART. 1 ON
OFF
Flash
02 (15/11/2013)
HAA263D
A. General status LEDs
B. Zone status LEDs
C. Control key buttons
System armed (whole system or one of the partitions)
System disarmed (the whole system)
System in exit delay period
AC power normal
AC power failure
System in Standby mode
Battery low
Battery normal
Battery under testing
System in Standby mode
System in programming mode
System in normal operation mode
Partition 1 armed
Partition 1 disarmed
During Exit Delay
3
VELLEMAN