Herunterladen Inhalt Inhalt Diese Seite drucken

Velleman HAA263D Bedienungsanleitung Seite 4

Wetterfestes bediengerät
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

PART. 2
ON
OFF
Flash
FORCED TO ARM
ON
OFF
Flash
B. Zone status LEDs
ON
OFF
Fast flashing
Fast flashing, 3x with
stopping interval
Slow flashing
C. Control key buttons description
There are 14 buttons for code entry and function confirmation
0 ~ 9
Numeric buttons for code entry
* #
For function confirmation
HOME
For home mode arming and programming
BYPASS
For (temporarily) bypassing zones while arming system
D. Audible keypad notifications
1 short beep
2 short beeps
5 short beeps
1 long beep
1 short beep/30 seconds
• Continuous short beeps at 0.5
second interval
• Beeping increases to 4 beeps/second
at the last 10 seconds
1 long beep at the end of the period
4 short beeps with 1 second interval
7. Programming
a. Set programming mode
• Make sure the system is in disarmed mode and the alarm memory is empty.
• Enable programming mode with the master code. Key in the master code, followed by
system generates 2 beeps for successful and 5 beeps for unsuccessful code entry.
• Factory default master code is 1234. For security reasons, it is strongly advised to replace this
master code with a personal code.
The PROGRAM LED is on and the system stops all its detection activities.
02 (15/11/2013)
HAA263D
Partition 2 armed
Partition 2 disarmed
During Exit Delay
System will be forced to arm if the faulty zone is not
cleared
System armed normally
System forced to arm with the faulty zone(s) bypassed
by the system
Zone abnormal
Zone normal
Zone was or still is in alarm mode
Zone was in alarm mode and is stored in alarm memory. System
is disarmed
Zone is bypassed
Successful key entry
Successful code entry for a specific function
• Unsuccessful code entry
Code entry time expired (Maximum Allowable
Time:10 seconds/digit, 60 seconds/code)
Exit delay expired, system is armed
Battery low or AC power failure
During the Exit delay, Entry delay and System
Standby period
After an alarm condition before the system is
disarmed
4
. The
VELLEMAN

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis