gns 2000 Anleitung Seite 7

Installation and Bluetooth mode
Position the GNS 2000 so that it has an unobstructed „view“
of the sky. Secure the receiver to avoid slipping. Switch on
the GNS 2000. Activate the Bluetooth mode in your Apple-
/ Android device / PDA / PC and initiate a search for the
GNS 2000 with your Apple / Android / PDA / Handheld /
tablet / PC devices Bluetooth manager. This is described
in the manual for your device. When you are asked for the
PIN to establish the link, enter „0000“.
Start your navigation software and select the appropriate
interface under the GPS settings if required.
The GNS 2000 can be connected to several Android devices
or SPP (serial port profile) devices simultaneously. For Apple
( IOS) devices only one exclusive connection at the same
time is possible.
Special feature for Apple devices: After the first connection
with an Apple device, the connection will be automatically
re-established when restarting the GNS 2000.
This automatic connection establishment will be interrupted
when you connect your GNS 1000 with another device
intermediately.
Operation over car ignition
For fixed and unfixed installation and operation in motor
vehicles with 12-24V power supply.
Due to the power management features described below
the GNS 2000 is prepared for fixed installation in motor
vehicles. If your vehicle is equipped with a cigarette lighter
socket which is connected to the car ignition and the GNS
2000 is connected via the included charging adapter and
the USB cable, the GNS 2000 will turn on automatically
when the car ignition is activated and will shut down auto-
matically 15 minutes after switching off the car ignition (on/off
switch of the GNS 2000 has to be in the position “on”).