EN
INSTRUCTIONS FOR USE
ABOUT THIS PRODUCT
This product was developed to increase the safety in the dark. The maximum vi-
sibility is approx. 300 m, depending on the charge status of the battery. Optional
blinking light, constant light or sensor function settings. (Image 1) The device is
splashproof and made from high-quality materials. You do not need batteries.
You can simply charge the device from any device with a USB connection, e.g.
your computer, using the USB cable included in the delivery.
INITIAL OPERATION OF THE PRODUCT
Before operating the product for the first time, please read through these directi-
ons for use carefully and store them in a safe place for future reference. Remove
the product from the packaging very carefully to prevent any damage. Now plug
the USB cable included in the delivery into the product (small connector) and
then connect the device to a USB port, e.g. on a computer. Only use the USB cable
included in the delivery to charge the product. (Image 2) The charging time is
approx. 1.5–2 hours. After the specified charging time, the product is ready to use.
For optimum visibility, please use additional safety accessories, e.g. a safety vest.
You can set the different lighting modes using the on and off switch: 1. Slowly
blinking light 2. Rapidly blinking light 3. Constant light 4. Sensor function.
When the on/off switch is pressed for 3 seconds, the device turns itself off
automatically (Image 1)
PLEASE NOTE
The run time of the blinking light is approx. 12 hours. The constant light lasts
approx. 6 hours before you need to charge the product again.
1275868.indd 22
28.03.18 09:59