Kiva Atlas X2 Benutzerhandbuch Seite 169

Malfunction, defect
Belts vibrate
extremely when
turning on the
mowing deck
The travel drive
belt of the machine
is slipping
The travel drive
belt is being
excessively worn
out
The machine does
not travel after
shifting into gear
The machine is
unusually loud
after shifting into
gear
The machine
loses power when
travelling up a hill
Extreme vibrations
occur when
travelling
The steering is
slipping through or
loose
The engine does
not run
 Check that the blades are not bent or twisted, also check that they are balanced. If they are
deformed, replace them.
 Check that the belt does not have burned areas or irregularities, which could cause the vibrations.
If the belt is damaged, replace it.
 Check that the blades are not worn out or damaged. Replace them if necessary.
 Check that the electromagnetic clutch switches properly. If the clutch is not working properly
have it replaced or repaired at an authorised service centre.
 Check the inside surface of the pulley on the engine. If it is coarse or has cracks, it is necessary to
replace the pulley.
 Check whether grass has accumulated on the underside of the mowing deck. It is necessary to
remove this grass.
 Check whether the defect is not in the engine mount. Tighten bolts or replace as necessary.
 Check the tension of the belt (
 Check the tension of the travel drive belt (
the tension spring, replace it if necessary.
 Check whether the belt is damaged or worn out.
 Check whether the movement of the clutch mechanism is blocked by a foreign object. If yes,
remove the foreign object.
 Check the engine pulley or transmission pulley for damage. Replace if necessary.
 Check belt tension.
 Check the tensioning mechanism, replace the damaged spring
 Check whether a foreign object is blocking the movement of the belt. If yes, remove the foreign
object.
 Check the condition of the pulleys - replace the pulleys if necessary.
 Check the gear shifting mechanism - attachment of the draw bar of the travel direction lever.
 Check the oil level in the equalisation tank
 Check the oil level in the equalisation tank and fill it up if necessary.
 There are air pockets in the hydraulic circuit – drive the machine on level ground forward and
back for several minutes. Contact your service centre.
 When the machine is under a high load and the ambient temperature is high, then the maximum
working temperature of the oil may be exceeded. Lower the work demands on the machine.
 Check whether any pulleys are damage or deformed. Replace them if necessary.
 Check whether the belt has any burned spaces or other irregularities. Replace it if necessary.
 Check the tension of the travel drive belt (
 Check that the mowing blades are balanced. Balance or replace them if necessary.
 Check that the space between the pinion and the segment is not too large. If yes, adjust the
cogged segment. Check for wear on the ball and socket joints. Replace the joints if necessary.
 Check that there is petrol in the petrol tank.
 Check that the prescribed procedure for starting the engine was followed (
 Check the fuse. Replace if necessary.
 Check whether the voltage on the battery terminals is 12 V. On a new machine check whether the
battery was activated and charged. On new machines replace the spark plug and check that there
is not oil accumulated on the cylinder due to incorrect handling.
 Check that all wire connections are in order and that the electrical system switches work.
 Check the engine again exactly according to the instructions in the User's manual of the engine
manufacturer. Have the electrical system checked at a specialised workshop.
Remedy
6.3.7. If necessary adjust the tension.
6.3.8). If necessary adjust its tension. Also check
6.3.8). If necessary adjust its tension.
171
5.2)