Permanent Installation - Hoover HWCB 15 Anleitung

INSTALLATION
IMPORTANT: Before installation and usage read all the instructions and make
sure that the voltage (V) and the frequency (Hz) indicated on the rating plate
are exactly the same as the voltage and frequency in your home. The rating
plate can be found on the front left edge of the inside of the Wine Cooler.
The manufacturer declines all responsibility in the event of the installer failing to
observe all the accident prevention regulations in force, which are necessary for
normal use and the regular operation of the electric system.
Electrical Connection
Positioning
o It is advisable that your appliance is only installed in a location where the
ambient temperature of the room, corresponds with the climate classification
that is stated on the rating plate of your appliance. Your appliance may not
function correctly if the ambient temperature falls outside of the following
ranges.
Climate classification
o Positioning the appliance requires two people in order to avoid injuries or
damage to the appliance.
o Your appliance should not be located in direct sunlight or exposed to conti-
nuous heat or extremes of temperature (e.g. next to a radiator or boiler).
If this is not feasible, then you should install an insulation plate between
the appliance and the adjacent heat source.
o You should check whether there is an electrical socket available, which will
be accessible after your appliance is installed.
o Place the appliance flatly and firmly on a solid base.
YOUR Wine Cooler IS INTENDED FOR FITTED AND

PERMANENT INSTALLATION.

We recommend that the appliance is connected by a
qualified electrician, who is a member of the N.I.C.E.I.C. and
who will comply with the I.E.E. and local regulations.
SN
N
ST
T
Appropriate ambient temperature
10 - 32 °C (50°F-90°F)
16 - 32 °C (61°F-90°F)
16 - 38 °C (61°F-100°F)
16 - 43 °C (61°F-109°F)
.21.