Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FOR INSTALLATION OFSKYMAXX PLUS ROOFLIGHT
WARNING!
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction.
CAUTION!
Disconnect main vehicle power before connecting
12 volt DC power to the MAXXAIR ROOFLIGHT!
STEP 6
Insert the 12 volt DC power supply wires into the large diameter
hole in the ceiling flange, allowing 4 to 6 inches of wire to hang
out. Note: Red wire from the wall control and black wire from the
negative terminal.
STEP 7
Insert the ceiling flange into the opening, lining up the flanges.
STEP 8
Referring to the screw lengths in the table of STEP 2, use the
proper length screws depending on your roof thickness to secure
the ceiling flange to the rooftop flange, taking care not to
overtighten the screws to avoid cracking or deforming the ceiling
flange and rooftop flange.
STEP 9
Optional: Install the screws to secure the ceiling flange to the
caravan ceiling. If the ceiling flange does not lay flat to the
ceiling, you may want to install screws to prevent gapping.
STEP 10
Using the supplied wire splices, connect the 12 volt DC power
supply wires to the LED light wires. Red wire from the wall
control to the red wire (pos) on the LED lights, and the black wire
from the negative terminal.
STEP 11
To assemble the Interior Shroud to the Ceiling Flange, line up
the flanges with the channels on the Ceiling Flange. Make sure
the power wires slide to the inside of the interior assembly and
do not become pinched or entangled. Secure in place by
pressing firmly on the Interior Shroud. This ensures that the clips
on the Interior Shroud will engage the channels on the ceiling
flange to lock it in place.
This completes the installation of the MAXXAIR
SKYMAXX Plus ROOFLIGHT.
Werbung
