Inhaltsverzeichnis
Werbung
DETERGENT SOLUTION TANK
Fill with clean water, with a lower temperature than 50°C, the solution tank (Fig.2) and add the detergent in the
concentration and with the antie ipated formalities from the manufacturer. To avoid the formation of an excessive
quantity off oam that would go to damage the motor of Aspiration, use the least percentage of detergent.
ATTENTION: To always use detergent with braked foam. To avoid with safety the production of foam, before
beginning the Job introduce in the recovery tank a least quantity of liquid not-foamy. Don't use aeids in pure State.
ATTENTION: Check that the corkis correctly inserted in his center and that the pipe feeding solution is correctly
grafled (B).
PREPARATION TO WORK
Top perform the operations of preparation of the machine described in precedence and then as follows:
BATTERY MACHINE:
Lower the squeegee lever (G) for proceeding to the Job.
1.
Rotate the general (K) interrupter and check that the green (D) led has turned on.
2.
Press the brushes interrupter (H).
3.
Press the aspiration interrupter (J).
4.
Regulate the quantity of detergent solution desire through the Special faucet (A).
5.
Press the electrical valve interrupter.
6.
CABLE MACHINE:
1.
Lower the squeegee lever (G) for pro- ceding to the Job.
Connect the thorn to the electrical supply and check that the green (V) spy has turned on.
2.
Press the brushes interrupter (H).
3.
Press the aspiration interrupter (J).
4.
Regulate the quantity of detergent solution desire through the Special faucet (A).
5.
Press the electrical valve interrupter (L).
6.
At this point the machine can work in full efficiency until to exhaustion of the detergent solution acting on the lever
of Operation that operates all the commands (M).
ATTENTION: the limiter (I), stop the brushes motor when this is submitted to a stranger effort than the one
thought in the project. To reset the electrical System wait one minute and then push the button. The machine is
ready to work again.
10
Werbung
Inhaltsverzeichnis
