Fitting Instructions
WARninG
Make sure that the LED flashers are
only installed and used according to
instructions. LED modules must not
be modified. Certification is rendered
invalid through manipulation.
Any applicable national guidelines
and regulations must be observed
for installation.
To rule out the risk of an electric
shock or short circuit, disconnect the
power supply before installation.
Make sure that the power supply
complies with the specifications on the
LED module.
Note that the LED flashers warm up
during operation.
iMPoRTAnT
Read carefully before use
Keep for later reference
www.herthundbuss.com
ECE R65 and KBA
certified version:
Preset to sync flash
Installation instructions:
The illuminants must be installed
using the supplied screws or the
optional rubber installation frame.
The illuminants must be installed
horizontally on a level surface
Make sure that the mounting seal
is in the correct position
84770605
4