TEC B-670 series Bedienungsanleitung Seite 26

12. GENERAL MAINTENANCE
7. Turn the pinch roller lever to the right.
8. Remove the white screw and detach the ribbon end sensor plate.
Stud
NOTE: When installing the ribbon end sensor plate, be sure to fit both studs in the notches of the ribbon
end sensor plate.
9. Remove the pinch roller block, then clean the roller belt and feed roller with cloth moistened by
alcohol.
Feed Roller
10. Reassemble the pinch roller block in the reverse order of removal.
Stud
Pinch Roller Lever
Roller Belt
E12-2
ENGLISH VERSION EO1-33016
12.1 CLEANING
White Screw
Ribbon End Sensor Plate
Fig. 12-2
Pinch Roller Block
Fig. 12-3