Werbung
Verfügbare Sprachen
Verfügbare Sprachen
G 8USPTVSBD86GÃFIDA Ã
23(5$7,21 $1' 86(
23(5$7,21
The power supply/control unit must be placed on a surface next to the
operator in such a way that:
- it is in a stable position with no risk of falling;
- the handpiece lead is not subject to excessive traction, thus avoiding the
risk of breakage of internal wires or dragging of the power supply unit;
- the functional status of the appliance can be checked easily.
Connect handpiece (1) to connector (2) located on the rear of the appliance
(by inserting the handpiece connector and turning the locking ring through
about 1/4 of a revolution until it stops - do not use excess force); Connect
electrode (3) to cable (4), which must be inserted in the "plate" socket (5)
on the front panel; the appliance can be activated using the button on the
handpiece (1); if you wish to activate the appliance using the pedal control
(6), connect the pedal cable to connector (7) on the rear of the appliance.
Finally, insert the plug on the power cable into a mains socket outlet.
)LJ
Now unscrew and remove the head, insert the required type of electrode
and then refit the head, tightening it appropriately to ensure the best
possible electrical continuity between the parts.
If the electrode cannot be inserted into the collet, extract the collet from its
location and push in the electrode with force; when the electrode has
been inserted, refit the resulting assembly into the handpiece and then
refit the head as described above.
Always sterilize the handpiece and electrodes before use; the handpiece
is specifically designed for sterilization in an autoclave.
$OZD\V VZLWFK 2)) WKH DSSOLDQFH DIWHU XVH E\ VHWWLQJ WKH PDLQ
SRZHU VZLWFK WR
IÃÃ%ÃÃ
8h…y‚ÃqrÃBv‚…tvÃ
Werbung
