Bediening; Driving And Steering The Truck With Handle; How To Take The Load; Drive With Load - Mammuth PT20L095 Bedienungsanleitung

4: If the forks do not elevate while pumping in RAISE position, turn the nut (Part No. 59)
counter-clockwise until the forks elevate while pumping in the RAISE position. Then check the
LOWER and DRIVE positions according to item 3.1, 3.2 and 3.3 .

4. Bediening

PLEASE NOTE! Check the device/the machine on missing/loose-fitting parts, deformations and
defects BEFORE EACH USE. In case one of the aforementioned faults is noticed, the device/machine
has to be decommissioned immediately.

Driving and Steering the truck with Handle

The handle is adjusted directly to the steering wheels. The
steering wheels will follow the position of the handle.

How to take the load

Drive the truck slowly in front of the pallet. Then, drive the fork
of the truck under the pallet up to end of the fork length. (Fig
5.A). Lift the load by pumping the handle at Raise position.The
load must be on the center of the hand pallet truck. Otherwise,
the hand pallet truck can be overturned.

Drive with load

It is necessary to pump the pallet truck to the right position to
drive. You must pay attention to the space between the bottom
Fig. 5
of the pallet and always keep the pallet clear of the floor. You should carefully drive the hand
pallet truck at a stable speed paying due care and attention to the environment around you.

Lowering the load

Lift the Lever to the Lower position, ensuring a free space behind. Then the truck can be pulled out of
the pallet. CAUTION! Do not lower the load while driving.

How to use the pallet truck on a truck

Only move the pallet truck slowly, at all times be careful that the hand pallet truck can not fall down
from the truck or the user will not be in the middle between the hand pallet truck and other loads. If
the pallet truck is not used, it must be firmly fixed on the truck when the truck is moving.
18