Herunterladen Diese Seite drucken

Technical Description; State & Battery - Helite B'SAFE SDU Bedienungsanleitung

Sattel-sensor

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

TECHNICAL DESCRIPTION

THE ELECTRONIC SYSTEM
The system uses an algorithm and two
sensors which are able to distinguish
cyclists' common movements in an
accident. The CDU sensor (crash
detection unit), located inside the vest,
analyzes cyclists' motion in real time
and the SDU saddle sensor detects
the shock. When an abnormal move
or a shock is detected both sensors
communicate with each other and
analyze the situation.
If an accident is detected, the airbag inflates in 80 ms and
the cyclist is protected.
STATE & BATTERY
Once installed and correctly paired (see first use section, page 18), the saddle sensor is totally autonomous (about 5 years). It is
constantly in sleep mode and only wakes up if a shock is detected on the bicycle. It is not necessary to take care of it often after
installation.
We recommend to check from time to time (once a month) if the saddle sensor is working properly.
To do so, you need to place the magnet over the round sign of the saddle sensor to check that the saddle sensor is still activated and
that it is still paired with the vest. Please note that this check should be done in an environment of more than 10°C.
User Guide - Saddle Sensor
(SENSORS AND ALGORITHM)
GREEN LED: BATTERY OK
RED LED: LOW BATTERY
You need to change the SDU sensor.
A Beep sound on the vest: the saddle sensor
and the vest are associated.
SHOCK AND ACCIDENT DETECTION
The electronic system detects different accident situations:
• During the ride (faster than 11km/h)
- Bicycles that hit or are being hit by a significant obstacle
(vehicle, wall, pole, etc.) from the front, side or rear.
- Loss of control of the bike (without shock on the bike):
slipping on the side or falling off the bike.
• Bicycle at a standstill
- Impact on the bicycle and the cyclist is ejected from the
bike.
In some accidents, if the movements are too slow,
!
or the amplitude is too weak, it is possible that the
detection does not work on time or not at all.
GOOD TO KNOW
To delete all the sensors that are
associated with the vest, press the
button
for 8 seconds.
22
23

Werbung

loading

Verwandte Produkte für Helite B'SAFE SDU