17
TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Machine stops or will not start
Machine slows down during
working
Bad grinding results
Grinding angle is wrong
MANY
POTENTIAL
CONNECTION TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you
have not the prescribed training for it always attract a workshop to fix
the problem.
HOLZMANN MASCHINEN GmbH
Possible cause
ON/OFF-switch damaged
Saw unplugged
Overload tripped
Fuse blown or circuit breaker
tripped
Cord damaged
Exerting too much pressure to
the sanding abrasive
Abrasive too coarse-grained
Adjusted angle is wrong
SOURCES
OF
ERROR
www.holzmann-maschinen.at
Check the switch
Check all power connections
Allow motor to cool and reset
by pushing off switch
Change fuse or reset circuit
breake
Change cable
Exert less pressure on the
work piece
Use less coarsed abrasive
Readjust the angle
CAN
BE
CLEARED
N O T I C E
TROUBLE SHOOTING
Solution
BY
THE
EXPERTLY
33
HMS 700 / HMS 1000