Box Contents; Rear Panel Overview - Alto Professional TS115PA TRUESONIC Schnellstartanleitung

BOX CONTENTS

•
TRUESONIC speaker
•
Power cable
•
Quickstart Guide
•
Safety Instructions & Warranty Information Booklet
CONNECTION DIAGRAM / INSTALLATION
Microphones*
Speaker
*Note: Microphones, mixer, and cables are not included.

REAR PANEL OVERVIEW

1. POWER INPUT – Connect the included power cable
to this input and connect the other end of the cable
to a power source.
POWER SWITCH is set to "off" when plugging and
unplugging the cable.
2. POWER SWITCH – Turns the speaker on/off. Make
sure the VOLUME knob is set to "zero" before
turning it on.
3. POWER LED – Illuminates when the speaker is on.
4. VOLUME – Turn this knob to adjust the speaker's
volume.
5. INPUT – Use a standard 1/4" TRS or XLR cable (not
included) to connect your sound source to this input.
6. MIX OUT – Use a standard XLR cable (not included)
to connect this jack to the input of another speaker
(i.e., another TRUESONIC speaker).
7. SIGNAL LIMIT LED – Illuminates when the audio
signal being sent to the speaker is "clipping" or
distorting. If this light illuminates frequently or
steadily, reduce the volume of your sound source.
8. CONTOUR – Engage (depress) this switch to
emphasize low and high frequencies by +3 dB.
Disengage the switch for flatter response for live performance or for maximum output.
9. GROUND SWITCH – Depressing this switch grounds the subwoofer, which can reduce hum or noise.
Power
Mixer*
Power
Make sure the speaker's
INSTALLATION:
This speaker should be installed on a
stand on the floor, according to its
maximum weight, or suspended from its
suspension points (M10 x 1.5PH, 30mm
length) (see example image). We do
NOT recommend suspending multiple
speakers in a vertical array.
Speaker
4
5
1
2
Example:
Eyebolt
Dust cover
Suspension
point
7
4
8
3
5
6
9
2