Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
5
1) Switch on the units by turning the level control (3) from the stop position.
The power indicator (2) lights up green. If it lights red, the batteries are
almost discharged and should be recharged or replaced.
2) Then use the channel selector switch (1) to select a free transmission
channel for the transmitter and receiver. Depending on the local
conditions, parallel use of up to 4 transmitters possible if you use the
following channels: 1, 2, 5 and 16.
CH
MHz
1
823.050
2
823.350
3
824.050
4
824.650
3) On the transmitter, adjust the desired volume for the audio signal
transmitted and on the receiver, adjust the desired playback volume.
Caution!
Never adjust a very high volume when using earphones. Permanent high
volumes may damage your hearing.
4) To switch off the units after use, turn back the level control (3) to the stop
past the snap-in point.
Troubleshooting
6
Check the following points in case of poor or disturbed reception:
1) Are the (rechargeable) batteries of the units exhausted?
2) Are all components connected correctly?
3) Is the transmission better when a different channel is used?
4) Are transmitter and receiver are too far apart?
5) Are there obstacles in the transmission path which may shield the radio
signal?
CH
MHz
5
825.150
6
825.850
7
826.350
8
826.750
13 • EN
CH
MHz
9
827.150
10
827.750
11
828.250
12
828.950
CH
MHz
13
829.450
14
829.950
15
830.350
16
830.850
Werbung
Inhaltsverzeichnis
Fehlerbehebung
