Sawing; Scraper; Maintenance - jcb -18MT Bedienungsanleitung

Make use of the corners and the triangular
m
shape of the sanding pad to sand places
that are difficult to reach.

Sawing

WARNING!
Hold the multi-tool by the insulated grips
when working in areas where the acces-
sory can come into contact with concealed
electrical cables. Contact with a live cable
will cause the metal parts on the tool to also
become live – risk of electric shock.
NOTE
Check before sawing that the saw blade
is straight and undamaged, and that the
planned cut is free from nails and screws etc.
Secure the workpiece with a clamp, clips
m
or vice.
Hold the multi-tool so that the saw blade
m
is not touching the workpiece. Start the
multi-tool and move the power switch
to position 1, and wait until the tool has
reached full power.

Scraper

Hold the multi-tool so that the scraper
m
is not touching the workpiece. Start the
multi-tool and move the power switch
to position 1, and wait until the tool has
reached full power.
Move the scraper at a slight angle to the
m
workpiece.
Do not overload the tool. Work by
m
applying a light pressure on the scraper.
Excessive pressure can lead to nicks and
marks in the workpiece, or overload the
multi-tool.
JCB-18MT
Instruction & User Manual
NOTE
For all these operations,
Use only with JCB batteries:
JCB-20LI, JCB-30LI, JCB-40LI and
JCB-50LI.

Maintenance

WARNING!
Switch off the tool and disconnect the power
(remove battery/unplug) before cleaning and
maintenance. This helps avoid the risk of
electric shocks and accidental starting.
Wipe the tool with a dry or damp cloth.
m
Do not use a wet cloth. Do not use
detergent that contains solvent or
corrosive, abrasive additives. This risks
damaging the surfaces of the tool.
Clear the tool vents and the accessory
m
mount of dust and dirt after each use.
Do not clean ventilation holes by
inserting sharp objects in them, such
as screwdrivers and other similar
objects.
Stubborn contamination in areas hard to
m
access can be removed with compressed air
(max 3. bar).
Regularly check all fasteners, screws and
m
bolts to make sure that they are tight.
Tighten any loose screws immediately or
serious injury could occur.
WARNING!
Never open the tool. The tool has no
internal parts that the user can service or
repair. Never try to repair the tool yourself.
Take to an authorised service centre.
15