Dedicated Micros Dennard 2025 Installationshandbuch Seite 15

No..
1
2
3
4
5
6
7
8
9
10
E.g. To add another control input to the unit, wire it into the terminal block marked with CTRL I/P 2
then set switch bank switches 6 and 7 on. When the contacts on the input switch are closed the
light will come on, if you want the light to come on when the input contacts are open then set bank
switch 7 to off.
If multiple switches are connected the light will switch on when any of the switches are on (OR
control).
2025 Installation Manual
Description
POWER CONTROL
1
UNUSED
ENABLE CONTROL
INPUTS
CTRL I/P 1 ENABLE
(PHOTOCELL)
CTRL I/P 1 TYPE
(PHOTOCELL)
CTRL I/P 2 ENABLE INPUT ENABLED
CTRL I/P 2 TYPE
CTRL I/P 3 TYPE
CTRL I/P 3 TYPE
POWER CONTROL
2
ON=
SEE POWER SETTINGS TABLE
ALWAYS IN ON
POSITION
INPUT ENABLED
CLOSED SWITCH
INPUT = ARRAY ON
CLOSED SWITCH
INPUT = ARRAY ON
INPUT ENABLED
CLOSED SWITCH
INPUT = ARRAY ON
SEE POWER SETTINGS TABLE
OFF=
-
INPUT DISABLED
OPEN SWITCH
INPUT= ARRAY ON
INPUT DISABLED
OPEN SWITCH
INPUT= ARRAY ON
INPUT DISABLED
OPEN SWITCH
INPUT= ARRAY ON
Factory Setting
OFF
OFF
ON
ON
ON
OFF
OFF
OFF
OFF
OFF
Page. 13