Direct Programming; Auto Search - Insignia universal 3 Bedienungsanleitung

1. Inserting batteries
Lift the cover of the battery compartment and
insert 2 1,5V AAA batteries respecting +/- polarity.
Online programming
1. Take note of brand and model of the
device you want to control.
2. Connect to site
www.gbs-elettronica.it/universal and follow
the easy guided procedure. If it is not possible
to connect to internet, please follow one of the
precedures described here below.

Direct programming

Search the brand of the device to be
controlled in the list that you can find in this
booklet (if you cannot find the brand, then launch
the auto search).
1. Press , or key you want to
program. The led of the key you pressed emits a
blink.
2. Press simultaneously and keys and
release them. The led turns on steadily.
3. Digit the first code corresponding to the brand
of the device to be programmed. If the led light
blinks three times that means that the code was
entered correctly. If the led light emits a long blink
and remains lit, then digit the code again or enter
the next code.
4. Verify that the device works correctly. If not all
the functions are there, then try with the next code
or launch the auto search.

Auto search

1. Turn on the device to be controlled, TV
or decoder, and point the remote control to it.
2. Press , or that you want to
program. The led of the key you pressed emits a
blink.
3. Press simultaneously and keys and
release them. The led turns on steadily.
4. Press the key, the remote control tries to
turn the TV off each 4 seconds using a different
code (the led light of the remote control remains
lit and blinks each 4 seconds). As soon as the
device to be controlled turns off, press any key of
the remote control. The led light emits a brief blink
and then it remains lit again.
5. Press key to verify that the device turns on
again (in some cases it is necessary to press key 1
to turn TV on). If the device does not turn on, press
6