Measurement Modes - Noblex NR 1000 Gebrauchsanleitung

Switch-on and switch-off
To switch on the rangefinder, press the " " (C) button. The switch-off is
always done automatically. After switching the device on again, it is in the
last used mode.
Automatic switch-off
If no button is pressed for a period of 30 seconds, the device switches itself
off automatically.

MEASUREMENT MODES

In addition to the standard mode, the device has 3 further modes between
which, depending on the application, you can change using the mode button
" " (D).
Depending on the weather conditions and the distance to the object to be
measured, it is possible to choose between the Rain mode "
for near objects " " and the mode for more distant objects "
symbol is shown at the top left of the field of view (4) (see back cover).
In the upper display line, the direct distance of the target (2) is shown.
In the second line, in all modes, except the standard mode, the horizontal
distance to the target object "HD" (7) can be read. In standard mode, the tilt
angle of the device "
The illustrations for the various display representations can be found in the
front cover.
I Standard mode
IV Long distances
I. Standard mode:
In this mode, the direct distance as well as the inclination angle of the
device to the target is measured. This mode does not have its own
symbol. When the standard mode is activated and the device is swiveled
up or down before the second pressing of the " " switch-on button, the
continuously changing tilt angle can be read in the field of view. The indi-
cated value is calculated from the angle between the measuring device,
target object and the horizontal (see back cover). If the switch-on button
is pressed again and the measurement was successful, the measured
distance as well as the angle of inclination during the measurement are
fixed in the display.
" (7) is displayed.
II Rain mode
V Complete display
mode
", the mode
". The mode
III Short distances
VI Brightness adjust-
ment in the complete
display mode
13