Operating Instructions Wireless Dmx-Control - Carpetlight CL8X8 Bedienungsanleitung

oPerAting instructions wireless dMX-control

The control unit features an internal CRMX interface, to enable wireless DMX control.
The status led shows the network status of your control unit:
LED-link:
(off)
(fast flashing)
Led-radio:
(slow flashing)
(on)
The interfaces default settings are not preset for a specific network, the connection to
a free network is done automatically when the master unit is scanning for new clients.
To separate the control unit from a network, keep the link switch pushed for more than
3 seconds.
To set the DMX address of your control unit, use the main menue, see functions 2. and 3.
Operating the control unit in wireless DMX mode is overriding the cable and manual
function.
Operating the control unit in cable DMX mode (using the 5pin XLR connectors) is
overriding the manual control.
no network configuration
network configured, no active wireless connection
active wireless connection, no DMX signal
active wireless connection, DMX signal present
unlink
link
radio
Link-Button Status-LED
not linked
no active radio link
active radio link, no DMX
active radio link, DMX
26
Antenna-Socket