Daylight Boost / Fast 100; Dmx-Starting Channel Selection; Dmx-Mode - Carpetlight CL8X8 Bedienungsanleitung

1. daylight Boost / fast 100%

Daylight Boost:
- Press the standby/menu button for 3 seconds (menu-mode).
- Rotate the brightness control 1 click to the right to activate the daylight boost .
-"Daylight Boost" will show up on the lower line of the display.
- Turning any control knob will bring back the lamp operation mode.
Fast 100 %:
The Lamp can, without using manual control, immediately be used at 100% brightness:
- Press the standby/menu button for 3 seconds (menu-mode).
- Rotate the color temperature control to the right for a 100% start.
- 100,0% will show up on the lower line of the display.
The lamp will switch back automatically into the lamp operation mode.
2. dMX-channel selection
Setting the DMX-channel Selection:
- Press the standby/menu button for 3 seconds (menu-mode).
- Press the standby/menu button briefly to go to the menu function "DMX".
- Use the color temperature control to select the required start address (1-511) .
- By pressing the standby/menu button again for 3 seconds you enter the wanted
input and revert to the lamp operation mode.

3. dMX-Mode

Turning off the DMX-Mode with connected DMX-Cable:
The control unit will automatically turn to the (DMX-Mode: Normal) once a DMX-Signal
is received.
By turning the DMX-Mode to "OFF" you can carry out manual alterations to the
DMX-Operation.
- Press the standby/menu button for 3 seconds (menu-mode).
- Press the standby/menu button briefly to get to the menu function "DMX-Mode".
- Use the color temperature control to choose the required input. DMX is on
"Normal"- DMX is off "OFF".
- By pressing the standby/menu button again for 3 seconds the input is
selected and the lamp reverts to the lamp operation mode.
Upon restarting the control unit will revert to the "ON" position, as long as a DMX-Signal
is present. Please note, when in DMX "Stand Alone "use, or when the lamp is the last in
the DMX chain, the use of a 120 Ω (Ohm) termination/load resistor could be necessary
(not included with the lamp).
4. display Backlight
Display Brightness:
- Press the standby/menu button for 3 seconds (menu-mode).
Menu functions
24