Operation; Select Modes - Kruger&Matz ODYSSEY Bedienungsanleitung

The subwoofer will enter the pairing mode and the pair indicator will blink
quickly.
3. Press the
main unit on.
4. After the wireless connection succeeded, the pair indicator will light up.
5. If the pair indicator blinks, the wireless connection has failed. Unplug the power
cable of the subwoofer, wait for around 4 minutes and connect it again. Repeat
steps 1 ~ 4.
NOTE:
• If the wireless connection fails again, check if there is conflict or strong
interference (for example, interference from another electronic device nearby).
Remove these conflicts or strong interferences and repeat the above procedures.
• The subwoofer should be within 6 m of the soundbar in an open area.
• If the main unit is not connected with the subwoofer and it is turned on, the
indicator will flash. Follow step 1 ~ 4 above to pair the subwoofer to the main
unit.
• Do not connect this soundbar to any other subwoofer nor connect this
subwoofer to any other audio amplifier.

OPERATION

Standby/ON
When you first connect the main unit to the power mains, the main unit will be in
standby mode.
1. Press the button on the unit or on the remote control to switch the unit ON.
2. Press the button again to switch the unit back to STANDBY mode.
3. Disconnect the mains plug from the mains socket if you want to switch the unit
OFF completely.
• If a Tv or an external device is connected via AUX or HdMI (CeC) connection, the
soundbar and the subwoofer will switch on automatically when the TV or the
external device is switched on:
- when connected via HDMI, the TV or external device has to support CEC
standard; otherwise the function will not be available.
- when connected via AUX, the function will be active on condition that the
input source level is high enough.
• When there is no input signal from the unit in over 15 minutes, then it will
automatically switch to standby mode.

Select modes

Press the button repeatedly on the unit or the SOURCE / HDMI buttons on the
remote control to select the AUX / OPTICAL / COAXIAL / HDMI 1 / HDMI 2 / HDMI ARC
/ USB / BT (Bluetooth) mode. The selected mode will show on the display.
30
button on the main unit or on the remote control to switch the
Owner's manual