Outdoor Unit (Doorbell); Installation; Mount The Indoor Unit (Monitor); Mount The Outdoor Unit (Doorbell) - Byron DIC-24112 Bedienungsanleitung

2. Home button
3. Touchscreen
4. MicroSD card slot
2.3

OUTDOOR UNIT (DOORBELL)

1. Microphone
2. Camera
3. Speaker
4. RFID
5. Call button (replaceable, extra button included)
6. Lock release time switch
7. Doorlock / gate switch
8. Register button (On the back of the unit)
3

Installation

3.1

MOUNT THE INDOOR UNIT (MONITOR)

To mount the monitor, you will need the following tools:
ü A suitable screwdriver for the included screws.
ü A drill and suitable drill bit for the included screw plugs.
A. Position the provided mounting plate where desired.
B. Mark the screw positions with a pen.
C. Drill the necessary holes.
D. Insert the plugs.
E. Pull the required cables through the mounting plate.
F. Fasten the mounting plate with the screws.
G. Attach the monitor to the mounting plate.
3.2 MOUNT THE OUTDOOR UNIT
(DOORBELL)
To mount the outdoor unit, you will need the following tools:
ü A suitable screwdriver for the included screws.
ü A drill and suitable drill bit for the included screw plugs.
A. Position the provided mounting plate where desired.
B. Mark the screw positions with a pen.
C. Drill the necessary holes.
D. Insert the plugs.
E. Use a knife or sharp object to puncture the cable gland.
F. Pull the required cables through the cable gland.
G. Fasten the mounting plate with the screws.
H. Attach the outdoor unit to the mounting plate.
I. Fasten the screw at the bottom.
3.3

ELECTRICAL INSTALLATION

3.3.1 Connecting the terminal blocks (Monitor
and Outdoor unit)
There are three terminal blocks included. The GREEN (outdoor unit
and ORANGE (AC power) terminal blocks are always required. In
case you wish to connect an additional monitor a BLUE terminal
block is also available.
To connect the terminal blocks, you will need the following tool:
ü A small flat head screw driver.
A. GREEN terminal block: Loosen the terminal screws.
Instruction manual
EN
7