Operation - NGS STEAM WIND Bedienungsanleitung

USER'S MANUAL

OPERATION

1. Plug the cord into the power outlet. The red LED on the
remote control will turn on when the machine is hot and
ready to steam. Normally this takes about 4 minutes after
connecting it to the outlet.
2. Press red key, the machine will spray fog (Press it as long
as you need).
3. Can set the machine at a high place (with hanger) or on the
ground. Do not spray fog to people directly and the lean
angle should less than 15.
4. Often check whether there has enough fog liquid in
machine. The operation will make big damage to the
machine if there has no fog liquid.
5. If the fog is small, machine has noise or there has no fog,
please power off and check fog liquid, fuse, the connector
of remote console and power plug. If the problem could not
be solved after check these parts, please stop check and
send it back to distributor for repair.
6
FOG MACHINE MAINTENANCE
Cleaning your fog machine
1. When not in use, pour all residual fluid out of the fluid tank
to the other empty bottle for next use.
2. Run out the fluid remain in pipes until clear.
3. Pour a mixture of 1/3 cup of white vinegar and 2/3 cup of
distilled water into tank.
4. After the machine has heated up to the proper
temperature, run the machine with mixture for 4-6 ejects.