Product Description - Fracarro D-MATRIX 4S-FTA Kurzanleitung

D-MATRIX-4S FTA is a unit that enables generating two modulated multiplexes according to the DVB-T or
DVB-C standards using streams received from four satellite transponders (DVB-S or DVB-S2), or read from
transport stream .TS file, contained in an external USB drive. The .TS files can be obtained by converting any
audio/video file
The modulator is full-band and therefore can independently modulate the 4 mux on arbitrary frequencies in
the VHF-S-UHF (114 ÷ 858 MHz) bands.
ATTENTION: the four MUX are not independent but are linked in pairs (MUX 1 / MUX 2) - (MUX 3 / MUX 4)
by the channel (or frequency) parameters, bandwidth and output level: if the output channel of MUX 1 (or
MUX 3) is set, the output channel of MUX 2 (or MUX 4) will be automatically set to the next adjacent channel
set for MUX 1 (or MUX 3).
If the output channel of MUX 2 (or MUX 4) is set, the output channel of MUX 1 (or MUX 3) will be automatically
set to the previous adjacent channel. Similarly, if a different value is set for the bandwidth or the output level
of MUX 1(or MUX 3), the same value will be set for MUX 2 (or MUX 4) and vice versa.
The product is equipped with:
● Bipolar electric power socket;
● Four DVB-S / DVB-S2 satellite inputs with DiSEqC management and overload control
● Four multicolour leds, one for each input, indicating the input status
● MIX input that enables mixing the signal generated from the device with one coming from a TV reception
system or other product that generates RF signals
● Ethernet 10base-T / 100base-TX Ethernet port
● RF output of the generated mux and whatever comes from the MIX input.
● USB host port for .TS file storage, the firmware update and configuration save/reset
● Multicolour led indicating the system status
● Reset button (internal)
RESTORE BUTTON: keep this button pressed for more than 2 seconds to delete the unit settings completely
and restore the factory parameters such as PASSWORD, USERNAME and NETWORK ADDRESS (given in
the WEB INTERFACE section of this guide).
D-Matrix-4S FTA PROGRAMMING:
to a local or remote PC network, by means of a LAN network
For detailed programming instructions for the D-Matrix-4S FTA, please refer to the INSTALLER'S
MANUAL, which you can download from the product page found at FRACARRO.IT.
SELF-CONFIGURATION PROCEDURE
Create a configuration by web
●
Export to a file from the Settings -> Operations menu. The file name will be All_data_ora.xml
●
Copy the file to a USB stick and name it FR_AUTOCONF_D-MATRIX-4S_FTA.FR (please pay
●
attention to lower case letters, dashes and extension)
● Insert the USB stick into another D-Matrix-4S FTA that must be switched on
the front LED will flash 3 times in green and orange and then D-Matrix-4S FTA will reboot
●
with the new configuration from the USB memory.
The self-configuration does not work if the D-Matrix is switched on after the USB stick is inserted.
Insert the USB stick while the unit is on.

PRODUCT DESCRIPTION

into the right
can only be performed using the web interface, connecting
format, using a
9
PC conversion
port.
program.