Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX actuator DC
The rutec DMX actuator controls and regulates 1 - 4 coloured LEDs by means of using DMX-512 signals. The DMX
start address can be set directly on the device via three push buttons.
Technical data:
Article no.
INPUT
80200
12/24 V DC
Product dimensions:
80200
OUTPUT
4 x 5 A 4 x 60/120 W
156.0
166.0
Wiring diagram:
DMX MASTER
Power supply
Netzgerät
12 24VDC
12-24V DC
N
L
230VAC
Operating Instructions:
Setting DMX address
Press the T1 button for 2 seconds. The DMX addresses is flashing on the display. Please press any key for 2 seconds to
confirm the address.
The required DMX-512 address can be set via three push buttons.
T1: setting 100 steps, T2: setting 10 steps, T3: setting single steps
Setting output channels
Press the buttons T2 and T3 simultaneously for 2 seconds. The different channels are flashing on the display.
Press T1 until "1 / 2 / 3 / 4" appears on the display (3= 3 channels; 4= 4 channels).
Press any key for 2 seonds to conform the quantity of output channels.
Factory setting: 4 output channels are set as standard version.
Setting of dimm frequency and dimming curve
Press the buttons T1 and T3 simultaneously for 2 seconds. "P_c" appears on the display (P=PWM frequency).
Press T1: "1" appears on the display and signified 1500 Hz.
Press T1 again: "2" appears on the display and signified 200 Hz.
With "c" you can set the dimming options. Press T3: "1" appears on the display and signified logarithmic dimming.
If you press T3 again, "2" appears on the display and signified linear dimming.
23.0
Factory setting: 200Hz and linear dimming are set as standard version.
N
Power supply
Netzgerät
230VAC
12 24VDC
12-24VDC
L
R
G
B
W
T3
T2
T1
Werbung
