Mac Os X Installation; Windows Installation; Connecting Your Blackmagic Hdlink Hardware - Blackmagic Design Hdlink Pro 3D Installations- Und Bedienungsanleitung

Mac OS X Installation

HDLink Utility runs on the latest Mountain Lion and Mavericks versions of Mac OS X.
HDLink Utility enables you to update your HDLink with the latest firmware. Firmware updates
may add new features, support new formats and standards, or provide increased compatibility
with other video and audio hardware. It is always best to use the latest version of HDLink Utility
so you receive all the latest updates for your HDLink.
The latest version of HDLink Utility can always be downloaded from
www.blackmagicdesign.com/support
After downloading the latest HDLink software and unzipping the downloaded file, open the
resulting HDLink Installer disk image to reveal its contents.
Launch the HDLink Installer and follow the on screen instructions. Restart your Mac when
prompted. HDLink is now installed.

Windows Installation

HDLink Utility runs on both 32 and 64-bit versions of Windows 7 and Windows 8.
HDLink Utility enables you to update your HDLink with the latest firmware. Firmware updates
may add new features, support new formats and standards, or provide increased compatibility
with other video and audio hardware. It is always best to use the latest version of HDLink Utility
so you receive all the latest updates for your HDLink.
The latest version of HDLink Utility can always be downloaded from
www.blackmagicdesign.com/support
After downloading the latest HDLink software and unzipping the downloaded file, you should
see an HDLink folder containing this PDF manual and the HDLink installer.
Double-click the installer and follow the on screen prompts to complete the installation. When
the installation has finished, it will prompt you to restart the computer. The restart will load a
USB driver for HDLink Utility so that it can communicate with any HDLink model. Click "Restart"
to complete the installation process. Once the computer has restarted, HDLink Utility will be
fully installed and ready to use.

Connecting your Blackmagic HDLink Hardware

After running the HDLink software installer, a USB driver will be installed on your system and
the HDLink Utility will be added to the Applications or Programs folder. To use the HDLink
Utility, you will need to connect HDLink as follows.
1 Connect the 12 volt power supply which was included with your HDLink. The white
power lamp will illuminate.
2 Connect a USB cable between HDLink and a USB 2.0 port on your computer.
Getting Started 6