Aux Mode; Specification - Kruger&Matz STREET 3 Wireless Bedienungsanleitung

headphones on, turn on the phone and enable Bluetooth function; the
headphone will connect with the device automatically.
• When in Bluetooth mode, when there is an incoming call the headphones
will switch to call automatically.

AuX moDe

To enter AUX mode, just plug in the cable. The headphones will turn off and
enter AUX mode automatically; then start the playback from the external device.
Note:
• the built-in microphone of the headphone will not work when under the
AUX mode.
• playlist management and volume control in AUX mode are available only
on the external device.
chArgIng
Connect the headphones to AC charger or a compatible computer USB port. Red
Led keeps lighting during charging. Once the charging is completed, the Led is off.
Note:
• use only original accessories to charge the headphones.
• charge the headphones at least once every 3 months to keep its battery in
good condition.
• the headphone's battery must be charged in order to use them in Bluetooth
mode. However, when using in AUX mode, the headphones will work even
if the battery is empty.

specIfIcAtIon

• Speake
r size: 40 mm
• Magnet: neodymium
• voice coil: CU
• Frequency response: 20 Hz- 20 kHz
• Impedance: 32 Ohm ± 15%
• S/N ratio: ≥80 dB
• SpL: 100 dB (@1 kHz)
• THd: ≤3% (@1 kHz)
• Sensitivity: 111±5 dB / 1 mW (@1 kHz)
• Nominal input power: 15 mW
14
Owner's manual