Use & Maintenance - Jacuzzi link Installationsanweisung

USE & MAINTENANCE
Functions
Showerhead (A)
Arranged in the middle of the shower crossbar, the showerhead
creates a large, rain shower jet.
Hand shower (B)
NOTE: After use, always position the hand shower on its support
facing towards the door: this will prevent accidentally spreading
water in the surrounding area if the door is open.
Vertical hydromassage (C)
This is equipped with simultaneous water jets issued from the
nozzles located on the wall.
The jets may be inclined in the four directions. Press the nozzle
and move them to the required position.
NOTE: An exclusive, patent-pending Jacuzzi® system
automatically cuts off the flow when the door is opened,
thus prevent spreading water in the surrounding area.
Tub filling (D)
The tub is fitted using the filler on the base of the shower column.
How to use the functions
GENERAL NOTES:
Never use water at temperature higher than 60°C to
prevent damage to the plumbing circuits.
NOTE: Two functions may be used at the same time. Simply turn
the dial of the diverter valve (G) mid-way between the
two functions. For example, if you want to use the vertical
hydromassage jets and the hand shower at the same
time, turn the dial between symbols (B) and (C);
obviously, the flow rate of the two functions will decrease.
Remember to close the stop tap (R) after each use. If
temperatures higher than 38 °C are selected, it is
advisable to turn the dial of the thermostat mixer back
before the safety stop.
Thermostat tap
A
It is advisable to adjust the water temperature to the desired value
before using any function as follows:
I Turn the knob (M) to make the reference notch coincide with the
chosen value. The knob is provided with a safety stop which blocks
the temperature at 38 °C; press button (P) to select hotter
temperatures.
I To test the water temperature, turn the diverter valve dial (G) to
the "tub filling" position (D) and turn the stop tap (R) to make water
flow.
I Once the required water temperature is reached, turn the dial (G)
to the position of the function you wish to use.
Note: It is advisable to return the diverter valve to the "tub filling"
position after using the functions.
12
B C D
R
38°
G
M
P