Morsø 2100 Montierungsanleitung Seite 4

Morsø 2110 Outside Air Kit
The kit consists of:
1. Remove the heatshields below and behind the stove.
They are both fixed with 4 bolts and 4 distance spacers.
2. Remove the air control rod which is fixed with a bolt, a washer, a spring
washer, and a spacer. Remember the position, of the 4 pieces.
3. Remove 5 of the 6 screws holding the frame for the control plate.
The screws are not to be used again.
Floor to center of the air collar:
Morsø 2110 with 6 in (152 mm) legs: 4,5 in (113 mm)
Morsø 2110 with 10 in (253 mm) legs: 8,4 in (214 mm)
Morsø 2140 with 10 in (254 mm) legs: 8,5 in (215 mm)
Morsø 2140 with 14 in (354 mm) legs: 12,4 in (315 mm)
Right side of the unit to center of air collar:
Morsø 2110: 10,6 inch (270 mm)
Morsø 2140: 10,2 inch (258 mm)
Air collar pipe:
inside: Ø3,9 inch (Ø100 mm)
outside: Ø4 inch (Ø102 mm)
4. Install the Outside Air box using the enclosed 5 longer screws.
5. Now install the rear heatshield on to the backplate of the stove.
6. The air control rod is led through the rectangular hole in the Outside Air
box. Be sure that that it catches the pin on the air control plate. The air
control rod is then fastened again using the removed 4 pieces (2). Control the
opening and closing function is controlled.
7. Finally fasten the bottom heatshield on to the stove. And the stove is ready
for use.
Installation Instructions
Morsø Jernstøberi A/S 09.08.2006 72180700
1 pcs. Outside Air Kit
5 pcs. screws 4.8 mm