Preparation For Use; Getting Started; Unpacking And Set Up - LEXIBOOK RCD150FE Bedienungsanleitung

PREPARATION FOR USE

GETTING STARTED

• Operate controls and switches as described in the manual.
• Before turning on the power, make certain that the AC Power cord is properly
installed.
• Store your CDs in a cool area to avoid damage from heat.
• When moving the unit, be sure to first disconnect the AC Power cord.

UNPACKING AND SET UP

• Carefully remove the main unit and the AC Power cords from the display carton.
Remove all the packing material from the unit. Remove any decorative or
descriptive labels from the front or top of the cabinet. Do not remove any labels
from the back or bottom of the cabinet.
• Carefully remove any small strips of tape that may have been used to prevent
the CD door from opening in transit.
• Unwind the AC Power cord and extend it to its full length.
• This unit was shipped with a dummy CD transit card in the CD player.
This dummy CD prevents the laser pick up from moving during shipment.
This card must be removed before you can insert your own CDs. Lift the CD Door
OPEN Tab to open the CD door. Carefully remove the dummy CD from the player
and discard it. Close the CD door.
• Place the unit on a flat, level surface such as a table, desk, counter, shelf,
etc, convenient to a 230V 50Hz AC outlet, out of direct sunlight, and away from
sources of excess heat, dust, moisture, or strong magnetic fields.
24