Crumb Tray; Cleaning And Care - Vitek VT-1584 BK Die Betriebsanweisung

Insert the power plug into the mains
–
socket.
Set the required toasting level using the
–
knob (8):
«1» – minimal toasting level;
«7» – maximal toasting level.
Notes: Set the control knob (8) to the position
you need. The toasting mode depends on the
thickness of the bread slice, bread sort and
quality; choose it experimentally.
Considering that heating element needs some
time to heat up after the first switching on, the
toasting level of the first toasts will be less at
the same position of the knob (8). To obtain
the same toasting level at the same position of
the knob (8) let the unit cool down for no less
than 30 seconds after switching off.
Press the lever (4) until clamping. The lever
–
(4) clamps only if the unit is plugged in.
After the lever (4) clamping the «STOP»
button (7) illumination will light up.
When the toasts are ready, the unit will be
–
switched off automatically, the lever (4) will
return to its initial position. The «STOP» but-
ton (7) illumination will go out.
To remove small toasts, carefully move the
–
carriage control lever (4) as upwards as
possible.
If you want to stop the toasting process,
–
press the «STOP» button (7).
Using the «DEFROST» button
To toast frozen toasts, put them into the slots
for bread toasting (3). Set the required toast-
ing level with the knob (8), press the lever (4)
until clamping and then press the «DEFROST»
button (5); the selected mode button illumi-
nation will light up. When the toasts are ready,
the unit will be switched off automatically, the
lever (4) will return to its initial position and the
button illumination will go out. To cancel the
selected mode press the «STOP» button (7).
Using the «REHEAT» button
You can warm up cold toasts. To do this, put
the toasts into the slots for bread toasting (3)
and press the carriage control lever (4) until
VT-1584.indd 5
it is fixed. Press the «REHEAT» button (6), the
button illumination will light up. After heat-
ing the unit will be automatically switched off,
the lever (4) will return to its initial position
and the button illumination will go out. In this
mode you can warm up toasts without addi-
tional browning. Press the «STOP» button (7)
to cancel.
Using the grid
If you want to warm up a roll, toast a slice of
bread only from one side or if the toast is of
irregular size, use the grid (2).
Press the lever (1), the grid (2) will extend.
–
Place a roll or a slice of bread on the grid
–
(2).
Set the toasting level using the knob (8):
–
Press the lever (4) until clamping.
–
When the toasts are ready, the unit will be
–
switched off automatically, the lever (4) will
return to its initial position.
After the end of operation carefully lift the
–
lever (1) to remove the grid.
CAUTION! During cooking the grid (2)
heats up strongly. Let the toaster cool
down before using the grid.
Attention: If smoke appears, press the
"STOP" button (7) immediately.

CRUMB TRAY

The toaster is equipped with a crumb tray (10).
Switch the unit off and let it cool down.
–
Remove the tray (10), clean it off the
–
crumbs and install the tray back to its place.

CLEANING AND CARE

Before cleaning the unit make sure that it
•
is unplugged.
Wait until the toaster cools down com-
•
pletely.
Clean the outer surface of the toaster body
•
with a damp cloth and then wipe it dry.
Do not use coarse sponges, abrasives and
•
solvents to clean the toaster.
• Do not use metal sponges for cleaning.
Wire pieces may get into the toaster and
cause a short-circuit.
5
ENGLISH
31.10.2017 10:15:37