Disposal; Technical Data; Packaging - Lidl 324180 Anleitung

Filament 1 1 is not being fed through:
1. Check that the filament 1 1 is inserted into the
filament entrance 3 properly and far enough.
2. Check that there is no excess of filament
sticking to the print head 8 that is causing a
blockage.
Filament 1 1 keeps flowing:
This can be a consequence of a small accu-
mulation of filament within the pen and has no
destructive consequences.
1. Lower the filament flowing speed temporarily
with the speed switch 7.
2. Stop your work for a few seconds and let the
accumulation be fed through.
Filament 1 1 gets clogged in the pen.
If PLA filament gets clogged in the pen, set
the switch 5 briefly to ABS position. Because
the melting temperature of ABS is higher, the
filament melts faster and becomes detached
from the pen.

9. Disposal

This product is subject to the provisions of the
European Directive 2012/19/EU.
The symbol of the crossed-out waste
container indicates that the product must
be discarded separately in the European
Union. This applies to the product and all
accessories marked with this symbol. Products
identified with this mark may not be disposed
of with normal household waste, but must be
delivered to a collection point for the recycling
of electrical and electronic devices.
Recycling helps to reduce the consumption
of resources and reduce the environmental
impact.
If you wish to discard the packaging,
comply to the environmental legislation in your
country.

10. Technical data

GB IE NI
Adapter
Input
Output
USB-cable
3D-pen
Dimensions
Weight
Material
Print head diameter
Melting temperature
Filament material
Protection
Environmental conditions
Status indicator
Power control

Packaging

Dimensions:
Material:
Content:
100-240V
5V 2A
1.50 m
18,5 x 4,5 x 3,2cm
60 gr
Print head = PPS plastic
Casing = ABS
0.7mm
Adjustable (with slider)
ABS settings 428 ± 50 ˚F
PLA settings 374 ± 50 ˚F
Pen is suited for1.75mm
diameter filament in PLA,
PETG or ABS plastic
IP40
Working temperature =
50 ~ 95 ˚F,
Humidity = 20~65%RH
LED-light orange = pen is
switched on and heating
LED-light green = pen is
ready for use
Manually with On/Off button
Automatic power off after
pen not used for 2 minutes
25,5 x 6.5 x 17,5 cm
Box = Carboard
Inlay = PET
3D-pen
5 Templates and 1 Drawing
pad
10 x 5m PLA-filament, in
ten colors
Adapter with USB-cable
and manual
7