Circulating Pumps CP50 Einbau- Und Betriebsanleitung Seite 8

English
1.4 Regulations
The current versions of the following regulations must be
observed during installation:
• Accident prevention regulations
• VDE 0370/Part 1
• Other local regulations (e.g. IEC, VDE, etc.)
1.5 Conversion and spare parts
Unauthorised modification and manufacture of spare parts
will impair the safety of the product/personnel and will make
void the manufacturer's declarations regarding safety.
The pump must not be technically modified or converted.
It is not permitted to open the pump motor by removing the
plastic lid. Only use original spare parts.
1.6 Transport/storage
Unpack and check the pump and all accessories upon
receipt. Report any damage sustained in transit immedi-
ately. Ship the pump in the original packing only.
The pump is to be protected against moisture and mechan-
ical damage and must not be exposed to temperatures out-
side the range –10°C to +50°C.
1.7 Electric current
There is a danger of an electric shock when working with
electrical current. Therefore:
• Switch off the power before beginning work on the pump
and make sure that it cannot be switched on again.
• Do not kink or jam the power cable or allow it to come into
contact with heat sources.
• The pump is protected against drips in accordance with IP
protection class (see rating plate). Protect the pump against
water spray. Do not immerse in water or other fluids.
4 4172332-Ed.01 (2012/07)