Product Description; Installation - D-D The Aquarium Solution DUAL HEATING & COOLING CONTROLLER Handbuch

PRODUCT DESCRIPTION

The Dual Heaing & Cooling Controller is designed to allow precise control of the
temperature in a marine aquarium.
The controller has 2 components:
1. Double mains power socket – one power socket for heater control and the other
for fan/chiller control.
2. Display with temperature sensor – used to set and display temperature and
alarms and measure temperature. The plastic coated temperature sensor is
waterproof and suitable for use in a marine aquarium.
Heaters of any type can be connected to the heating power socket (socket marked
with a " " symbol). The maximum rating is 1,600W.
The cooling power socket is provided for controlling fans or coolers, (socket marked
with a " " symbol). The maximum rating is 1,600 Watt, however, due to the high
starting current of inductive loads such as a chiller, the maximum power rating for
these devices is 600W maximum.

INSTALLATION

•
Position the temperature sensor in the aquarium so that the probe end is
completely submersed at all times in the aquarium water. Position this sensor
probe in an area that is well away from any heater or chiller water return (failure
to observe this can result in inaccurate temperature control).
•
Connect a heater to the heater power socket (if the heater has a built-in
thermostat, be sure to set the thermostat temperature higher than the aquarium
temperature to prevent the thermostat from disabling the heater).
•
Connect a fan/chiller to the cooling power socket (if the chiller/fan has
a thermostat, be sure to set the thermostat temperature lower than the aquarium
temperature to prevent the thermostat from disabling the chiller).
•
Connect temperature controller to power and switch
4
D_D Dual Heating & Cooling Controller Multi Language V4 125x178mm.indd 4
on.
08/07/2019 14:32